I laid out and drilled the holes that tie the inside of the passenger foot box to the forward transmission tunnel cover and seat floor and then drilled the holes that tie the side wall of the transmission tunnel cover to the forward transmission tunnel cover.
The inside wall of the passenger foot box can still move around a bit, so I used some welding magnets to lock it into position so that I can figure out where to cut the floor and where to mount the angles.
While I had the seat floor out, I laid out some holes that will tie it to the transmission tunnel. I still need to fabricate a cover for the old emergency brake access hole.
I laid out a few additional holes near the back of the seat floor.