Installed PCV Valve

I received the M/E Wagner PCV valve in the mail today. I cut a couple of pieces of the silicone hose and had it installed in just a few minutes.

The inlet on the bottom of the unit is aligned with the breather cap and the outlet on the side is aligned with the nipple on the throttle body.

The adjustment screws will be easy to reach from the left side of the engine by reaching under the air cleaner. Getting to the calibration port may be a little more challenging as it’s basically on the bottom of the unit. Although these hoses are under vacuum, I will probably add some worm clamps to them.

Leave a Reply

Your email address will not be published. Required fields are marked *